Improved quality for maximum break resistance – the new Streifytec PETG 111P69
New formulation / quality / recipe of PET which makes the material more break-proof and impact-resistant than (Streifeneder’s) conventional PETG, almost "unbreakable" so to speak.
This greatly reduces the risk of cracking when demolding, drilling, grinding and improper use.
This makes handling the material a lot easier and saves time / effort / nerves / money if necessary.
The fracture and the associated risk of falling and injury are also significantly reduced for the patient.
Break test
Flyer
Hazard goods: No
Item Code:
111P69/12 - Streifytec PETG, 400x400x12 mm
111P69/15 - Streifytec PETG, 400x400x15 mm
General product information:
Transparent
Odorless
Biocompatible
Disinfectable
Properties / technical. Data:
Activation temperature: approx. 160 ° C (320 ° F)
Activation time in the infrared oven for:
12mm thickness approx. 12min
15mm thickness approx. 15min 30sec
Maximum shrinkage when activated 0.2-0.5%
No shrinkage during cooling.
Impact resistance (Izod): no breakage
Flexural modulus: 1375 MPa
Material (including care instructions):
PETG polyethylene terephthalate with glycol
Keep away from acids and bases.
Not resistant to acetone.
Conditionally resistant to acrylic resins (especially sealing resin)
laminating is perfectly fine
Indications:
Interim sockets (if laminated)
Trial sockets
Trial orthotics
Face masks
Contraindications:
Orthotics with load bearing.
Trial orthoses (joints)
Special features / information (attention applies to all PET):
Store the material in a dry place, protected from sunlight, between 10 and 40 ° C.
Can be made usable again if it absorbs moisture (it creates bubbles when heated).
Rule of thumb: 1 hour at 100 ° C in the oven for every 1 mm of material thickness.
Advantages of the product:
Extremely high impact resistance
Very high breaking strength
Less wear during production
Disadvantages of the product:
Like every PET it’s hygroscopic. (Absorbs moisture, also from the air)
Comments